1. Put on the disposable gloves. Open the white plastic tube and slide the ink roller out of the container onto a plastic bag or paper towel. Insert the hollow tube into the axle hole in the roller. The tube should fit so it is approximately flush with both ends of the ink roller.

2. Attach one acorn nut, finger-tight, to one end of the roller axle. Slip the free end on the axle through one of the handle bracket assembly arms until it protrudes about 1/2 inch. Slip a washer over the end of the axle.

3. Slide the roller onto the axle. Slide the axle through the roller until the threaded end is visible. Slip the remaining washer over the end of the axle. Note that the washer goes between the roller and the handle assembly arm.

4. Slide the axle through the second handle bracket assembly arm. Attach the remaining acorn nut to the end of the axle. Tighten both acorn nuts. Place the vinyl caps over the acorn nuts.

5. Prepare the roller for use by gently wiping the roller surface with one of the towelettes provided to remove areas of excess ink. Dispose of all packing materials and remove gloves. Use the remaining towelette to clean hands as necessary.

Introduction

The goal of latent print examiners and technicians is to discover and collect latent prints by various means. The ultimate goal is to identify those latent prints to the person responsible for the criminal act and prosecute them to the fullest extent of the law. Some of these means to develop latent prints include processing evidence and other surfaces using powders, chemicals and lighting techniques. The purpose of this booklet is to provide a resource of information about latent print processing techniques. This booklet does not contain every process available and does not claim to be all inclusive of all variations of processes. The information has been collected from various sources.

Caution

This booklet contains descriptions of processes utilizing chemicals or combinations of chemicals which may be hazardous to the user's health. It is strongly recommended that proper precautions be taken when using hazardous chemicals or combinations thereof. Safety equipment needed may include fume hoods, gloves, protective clothing, safety goggles, splash shields or respirators. It may be necessary to store these chemicals in specific containers or cabinets. It is the user's responsibility to know and use the proper and adequate safety equipment required the various chemicals listed.

Disclaimer

Lightning Powder Company, Inc. assumes no responsibility for the use or misuse of any of the chemicals, procedures, methods of ideas described herein resulting in injury and/or damage to persons or property.
Copyright ^© 1998 Lightning Powder Company, Inc.
The material contained in and displayed by this website may be reproduced with acknowledgment of its source.